| 基于UG NX的球孔加工夹具设计 |
| |
| 引用本文： | 孙义林,胡增荣,赵利润,徐华.基于UG NX的球孔加工夹具设计[J].机械工程师,2013(10):66-68. |
| |
| 作者姓名： | 孙义林 胡增荣 赵利润 徐华 |
| |
| 作者单位： | 1. 苏州大学,江苏苏州,215131
2. 新宇航空制造(苏州)有限公司,江苏苏州,215021 |
| |
| 摘 要： | 以航空零件球孔加工夹具设计为例,介绍了应用UG NX8.O软件进行夹具设计及三维建模的方法,通过创建夹具三维模型,采用自上向下的装配方式完成夹具的装配及夹具体不同位置的调整,阐述了UG软件WAVE几何连接器的功能,同时介绍了软件的强大建模、工程制图功能以及分析计算功能,应用该软件提高了设计质量,缩短了开发周期,提高了企业的自主研发能力和竞争力.
|
| 关 键 词： | UG NX 球孔 夹具设计 |
Fixture Design for Processing Ball Hole Based on UG NX |
| |
| SUN Yi-lin
,
HU Zeng-rong
,
ZHAO Li-run
,
XU Hua.Fixture Design for Processing Ball Hole Based on UG NX[J].Mechanical Engineer,2013(10):66-68. |
| |
| Authors: | SUN Yi-lin HU Zeng-rong ZHAO Li-run XU Hua |
| |
| Affiliation: | 1.Soochoow University, Suzhou 215131, China; 2.SAM(Suzhou), Suzhou 205021, China) |
| |
| Abstract: | Taking the aerial part＇s ball hole jig design processing for example, UG NXS.0 software was used to design and build 3D modeling of fixture. Top-down assembly method was used to assembly the fixture and adjust the position of the different parts of the fixture. UG software WAVE geometric connector function, the software powerful function modeling, engineering drawing and analysis functions, were explained. These function can improve the design quality, shorten the development cycle, improve the company research and development capability and competitiveness. |
| |
| Keywords: | UG NX ball hole fixture design |
| 本文献已被 维普 万方数据 等数据库收录！ |
|
