| 注塑成形CAE系统分析模型研究 |
| |
| 引用本文： | 李阳,周华民,李德群.注塑成形CAE系统分析模型研究[J].中国机械工程,2006(Z1). |
| |
| 作者姓名： | 李阳 周华民 李德群 |
| |
| 作者单位： | 华中科技大学塑性成形模拟及模具技术国家重点实验室，华中科技大学塑性成形模拟及模具技术国家重点实验室，华中科技大学塑性成形模拟及模具技术国家重点实验室 武汉，430074，武汉，430074，武汉，430074 |
| |
| 摘 要： | 目前共有4种分析模型应用于注塑成形CAE系统:1维分析模型;2·5维中面分析模型;2·5维双面网格分析模型;3维实体分析模型。详细讨论了2·5维中面分析模型,2·5维双面网格分析模型和3维实体分析模型3种分析模型的优缺点,并通过理论分析和实例模拟结果的比较,研究了不同分析模型对注塑分析结果的影响,提出了在使用CAE系统中选择分析模型的规则。
|
| 关 键 词： | 注塑成形 CAE 分析模型 中面模型 双面模型 实体模型 |
Investigation on the Analysis Model of the Injection Molding CAE System |
| |
| Li Yang Zhou Huaming Li Dequn State Key Laboratory of Plastic Forming Simulation and Die & Mould Technolog y,Huazhong University of Science and Technology,Wuhan.Investigation on the Analysis Model of the Injection Molding CAE System[J].China Mechanical Engineering,2006(Z1). |
| |
| Authors: | Li Yang Zhou Huaming Li Dequn State Key Laboratory of Plastic Forming Simulation and Die & Mould Technolog y Huazhong University of Science and Technology Wuhan |
| |
| Affiliation: | Li Yang Zhou Huaming Li Dequn State Key Laboratory of Plastic Forming Simulation and Die & Mould Technolog y,Huazhong University of Science and Technology,Wuhan,430074 |
| |
| Abstract: | At present, there are four models used in injection moldi ng ,i.e. one dimension model,2.5D middle-plane model, 2.5D fusion model and 3D solid model. Except the one dimension model, the advantages and the disadvantages are discussed. The influence of the different models on the injection molding an alysis is also studied. The rule for choosing the analysis models in the injecti on molding CAE system is brought forward. |
| |
| Keywords: | injection molding CAE analysis model middle-plane model fusion model solid model |
| 本文献已被 CNKI 等数据库收录！ |
