| 不同凹模型面对管材正挤压的影响 |
| |
| 引用本文： | 贺琳,王忠堂,赵根发,邓永刚. 不同凹模型面对管材正挤压的影响[J]. 沈阳理工大学学报, 2009, 28(6): 28-30,27 |
| |
| 作者姓名： | 贺琳 王忠堂 赵根发 邓永刚 |
| |
| 作者单位： | 沈阳理工大学,材料科学与工程学院,辽宁,沈阳,110159 |
| |
| 基金项目： | 国家自然科学基金资助项目 |
| |
| 摘 要： | 通过对不同凹模型面进行的管材挤压实验，分析了半模角α和曲面形状对挤压力的影响．采用MSC．Marc软件对成形过程进行了数值模拟．研究结果表明，随着半模角α的增大，曲面模的挤压力有变小的趋势．当α在60°～70°，锥模的挤压力最小，材料利用率最高．
|
| 关 键 词： | 凹模型面 挤压 管材 挤压力 |
Effect of Different Cavity Profile of Extrusion Die on Forward Extruded Tubes |
| |
| HE Lin,WANG Zhong-tang,ZHAO Gen-fa,DENG Yong-gang. Effect of Different Cavity Profile of Extrusion Die on Forward Extruded Tubes[J]. Transactions of Shenyang Ligong University, 2009, 28(6): 28-30,27 |
| |
| Authors: | HE Lin WANG Zhong-tang ZHAO Gen-fa DENG Yong-gang |
| |
| Affiliation: | ( Shenyang Ligong University, Shenyang 110159, China) |
| |
| Abstract: | The influence of different half cavity angle α and camber shape on the extrusion force has been analyzed through the experiment of cavity profile of extrusion die in this paper. Based on this, with MSC. Marc software, the simulation of tube forming process is cartied out. The results show that the extrusion force of cavity die is reduced with the increasing of angle α . And when α is 60° - 70°, cone die adopted, minimal force and highest utilization are obtained. |
| |
| Keywords: | die profile extrusion tube extrusion force |
| 本文献已被 维普 万方数据 等数据库收录！ |
|
