| 基于Pro/E的注塑模成型零件的充模及开模仿真 |
| |
| 引用本文： | 魏延宏,杨萍.基于Pro/E的注塑模成型零件的充模及开模仿真[J].兰州工业高等专科学校学报,2006,13(3):33-36. |
| |
| 作者姓名： | 魏延宏 杨萍 |
| |
| 作者单位： | 1. 兰州理工大学,机电工程学院,甘肃,兰州,730050;兰州石化职业技术学院,机械工程系,甘肃,兰州,730060
2. 兰州理工大学,机电工程学院,甘肃,兰州,730050 |
| |
| 摘 要： | 传统的注塑模具设计主要依靠模具设计师的直觉和经验,模具通常要经过反复的调试和修正才能投入生产,模具的设计周期长,成本高.利用Pro/E软件设计模具,可以通过模具的充模和开模仿真,检查所设计模具成型零件的合理性,减少模具设计周期,降低生产成本.以滑动器模具为例,介绍了模具成型零件的充模仿真和开模仿真的过程.
|
| 关 键 词： | Pro/E 成型零件 充模仿真 开模仿真 |
| 文章编号： | 1009-2269(2006)03-0033-04 |
| 收稿时间： | 04 17 2006 12:00AM |
| 修稿时间： | 2006年4月17日 |
Simulation of Molding and Mold Opening for Mold Shaping Part Based on Pro/E |
| |
| WEI Yan-hong,YANG Ping.Simulation of Molding and Mold Opening for Mold Shaping Part Based on Pro/E[J].Journal of Lanzhou Higher Polytechnical College,2006,13(3):33-36. |
| |
| Authors: | WEI Yan-hong YANG Ping |
| |
| Abstract: | Traditional mold designers usually depend on their intuition and experience.Mould is always debug and corrected again and again before it can be used in production.The mold design cycle is long and the cost is high.Simulation of molding and mold opening by Pro/E software can help testify the reasonability of mold shaping part designing,it can also shorten the period of mould design and lower the product cost.Taking slide part as an example,the whole process of simulation of molding and mold opening for mould shaping part of designing is briefly introduced. |
| |
| Keywords: | Pro/E shaping part simulation of molding simulation of mold opening |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
