Analysis of tool wear and residual stress of CVD diamond coated cemented carbide tools in the machining of aluminium silicon alloys

Aluminium alloys have found increasing applications in the automotive and aeronautical industries in recent years. Due to their extraordinary properties however, the machining of these alloys still poses difficulties, and requires the optimized combination of cutting tool material and geometry. The potential of CVD diamond coated carbide tools has been demonstrated in recent years, however tool wear and short tool life remain as issues to be resolved. Key to increasing the tool life of CVD diamond coated tools is the further development of the coating process to optimize the coating adhesion. An understanding of the substrate and coating residual stress profiles must be gained in order to achieve this. Compressive residual stresses in cutting tools can lead to a higher crack resistance, but also to early coating delamination and tool failure. To analyze the influence of residual stresses on the coating quality and tool life, the residual stress profiles of tungsten carbide substrates and CVD diamond coatings were measured using X-ray and synchrotron radiation. The influence of the tungsten carbide substrate type and the CVD diamond coating process on the residual stress profiles was thus determined. In order to analyze the performance of the coated tools and the influence of the residual stresses on the tool lifetime, machining tests were performed with two aluminium silicon alloys. The tool wear, tool lifetime and workpiece quality were examined. Finally, many of the commonly used wear tests used to analyze the wear resistance of tool coatings cannot be implemented for CVD diamond coatings due to their high hardness. An impact test was therefore constructed to allow the determination of the wear resistance of CVD diamond tools.