| Abstract: | An ion generator was developed to neutralize concentrated streams of large, highly charged particles in a low-velocity wind tunnel. The aerosol stream tested consisted of 30 mu m aluminum oxide particles (aerodynamic diameter 52 mu m) at a flow rate of 9.6 m3/h (160 L min) and a mass concentration of 43 g/m3. The average number of excess charges per particle was 240,000 (positive), which corresponds to a neutralizing current requirement of 0.11 mu A. Neutralization to < +/- 10,000 charges per particle was necessary to prevent electrostatic sampling artifacts. Neutralization with radioactive sources would have required an impractically large source. The ion generator, constructed from 21 and 32 mm PVC pipe, has 4 peripheral radial electrodes of 0.5 mm tungsten wire and a 2.0 mm diameter central electrode. The aerosol flowed through the ion generator along its axis. The ion generator was powered by an adjustable (0-8.5 kV) power supply. Performance of the ion generator was monitored with an isokinetic Faraday-cup sampler connected to a Keithley Model 6512 electrometer capable of 0.1 fA resolution. The sampler used a stainless steel 47 mm filter holder as the Faraday cup. The cup was insulated with Teflon inside a 90 mm diameter stainless steel enclosure with a 21 mm diameter inlet. This setup gave near real-time measure ment of the charge state of the aerosol in the wind tunnel. By adjusting the ion generator power supply, particle charge could be reduced to < 2% of its original charge. Ion generator output was sufficiently stable to maintain the particle charge within +/- 2% of the original charge over a 1 h period. These reduced charge levels are comparable to charge levels found on workplace aerosols. |
