| 端子级进模设计 |
| |
| 引用本文： | 洪朝阳. 端子级进模设计[J]. 模具工业, 2008, 34(6): 26-29 |
| |
| 作者姓名： | 洪朝阳 |
| |
| 作者单位： | 厦门宏发电声有限公司,福建,厦门,361021 |
| |
| 摘 要： | 通过对零件电镀工艺的选择及相关排样的对比分析确定了排样方案,并介绍了排样设计与模具结构要点,模具生产的零件质量稳定,成本低,对同类零件的模具设计具有一定的借鉴作用。
|
| 关 键 词： | 条料电镀 级进模 排样设计 滑块抽芯 |
| 文章编号： | 1001-2168(2008)06-0026-04 |
| 修稿时间： | 2008-01-15 |
A progressive die for leading-out terminal |
| |
| HONG Chao-yang. A progressive die for leading-out terminal[J]. Die & Mould Industry, 2008, 34(6): 26-29 |
| |
| Authors: | HONG Chao-yang |
| |
| Abstract: | The layout design was determined based on the selection of electroplating process for the leading-out terminal in an electromagnetic relay and a comparative analysis on related layout.The key points in the layout design and the structure of a die for shaping the component were stated. |
| |
| Keywords: | electroplating of coil strip progressive die layout design slide block core-pulling |
| 本文献已被 维普 万方数据 等数据库收录！ |
|
