Effect of supplementary firing options on cycle performance and CO2 emissions of an IGCC power generation system

Supplementary firing is adopted in combined‐cycle power plants to reheat low‐temperature gas turbine exhaust before entering into the heat recovery steam generator. In an effort to identify suitable supplementary firing options in an integrated gasification combined‐cycle (IGCC) power plant configuration, so as to use coal effectively, the performance is compared for three different supplementary firing options. The comparison identifies the better of the supplementary firing options based on higher efficiency and work output per unit mass of coal and lower CO₂ emissions. The three supplementary firing options with the corresponding fuel used for the supplementary firing are: (i) partial gasification with char, (ii) full gasification with coal and (iii) full gasification with syngas. The performance of the IGCC system with these three options is compared with an option of the IGCC system without supplementary firing. Each supplementary firing option also involves pre‐heating of the air entering the gas turbine combustion chamber in the gas cycle and reheating of the low‐pressure steam in the steam cycle. The effects on coal consumption and CO₂ emissions are analysed by varying the operating conditions such as pressure ratio, gas turbine inlet temperature, air pre‐heat and supplementary firing temperature. The results indicate that more work output is produced per unit mass of coal when there is no supplementary firing. Among the supplementary firing options, the full gasification with syngas option produces the highest work output per unit mass of coal, and the partial gasification with char option emits the lowest amount of CO₂ per unit mass of coal. Based on the analysis, the most advantageous option for low specific coal consumption and CO₂ emissions is the supplementary firing case having full gasification with syngas as the fuel. Copyright © 2008 John Wiley & Sons, Ltd.