| 基于PLC的滑动轴承对接平面拉床控制系统 |
| |
| 引用本文： | 陈其祥,耿璐,周海海,陈黎. 基于PLC的滑动轴承对接平面拉床控制系统[J]. 机电工程, 2007, 24(3): 28-31 |
| |
| 作者姓名： | 陈其祥 耿璐 周海海 陈黎 |
| |
| 作者单位： | 淮南联合大学,机电工程系,安徽,淮南,232001;中国矿业大学,机电与信息工程学院,北京,100083;南京航空航天大学,机电学院,江苏,南京,210016 |
| |
| 摘 要： | 对开滑动轴承的对接平面精加工是该类产品工艺流程的关键工序.在分析该工序加工工艺过程的基础上,阐述了采用PLC进行全自动液压对接平面拉床控制系统技术改造的设计过程,并说明了其中的相关技术问题.实验证明,该系统运行稳定.
|
| 关 键 词： | 可编程控制器 液压系统 机床改造 拉床 滑动轴承 |
| 文章编号： | 1001-4551（2007）03-0028-04 |
| 修稿时间： | 2006-08-15 |
Control system of broaching machine for bisect plane machining of sliding bearing based on PLC |
| |
| CHEN Qi-xiang,GENG Lu,ZHOU Hai-hai,CHEN Li. Control system of broaching machine for bisect plane machining of sliding bearing based on PLC[J]. Mechanical & Electrical Engineering Magazine, 2007, 24(3): 28-31 |
| |
| Authors: | CHEN Qi-xiang GENG Lu ZHOU Hai-hai CHEN Li |
| |
| Abstract: | The finish machining of the bisect plane of bisect sliding bearing is the key working procedure of the machining process of such products.The design process of the reform of the machine tool control system of automatic hydraulic broaching machine for bisect plane machining by applying PLC on the basic of analyzing the machining process of this working procedure was discussed,and the relative technical problems were explained.Experiment result shows that the system run realibility. |
| |
| Keywords: | programmable logic control(PLC) hydraulic system reconstruction of machine tool broaching machine sliding bearing |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
