| 基于Moldflow的充电器底座注射成型流动分析 |
| |
| 引用本文： | 沈剑,王传洋,钱秋波.基于Moldflow的充电器底座注射成型流动分析[J].模具工业,2011,37(4):45-48. |
| |
| 作者姓名： | 沈剑 王传洋 钱秋波 |
| |
| 作者单位： | 苏州大学机电工程学院,江苏苏州,215021 |
| |
| 基金项目： | 江苏省高校自然科学基金项目(09KJB460010); 苏州市国际交流与合作基金项目(SWH0927) |
| |
| 摘 要： | 利用Moldflow软件对充电器底座注射成型过程中最佳浇口位置和流动情况进行分析,确定了最佳浇口位置,分析了熔体流动的填充时间、前沿温度、体积剪切速率和压力分布变化情况,气穴和熔接痕位置。通过模拟结果找出缺陷产生的原因,改善工艺参数。
|
| 关 键 词： | Moldflow 注射成型 流动分析 |
Moldflow-based flow analysis on injection molding for charger base |
| |
| SHEN Jian,WANG Chuan-yang,QIAN Qiu-bo.Moldflow-based flow analysis on injection molding for charger base[J].Die & Mould Industry,2011,37(4):45-48. |
| |
| Authors: | SHEN Jian WANG Chuan-yang QIAN Qiu-bo |
| |
| Affiliation: | SHEN Jian,WANG Chuan-yang,QIAN Qiu-bo(School of Mechanical and Electric Engineering,Soochow University,Suzhou,Jiangsu 215021,China) |
| |
| Abstract: | Analysis was made on the optimal gate location and flow behavior in injection molding of a charger base was simulated by Moldflow and the optimal gate location was determined.The filling time of melt flow,front temperature,volumetric share rate,pressure distribution,the location of air pockets and weld lines were analyzed.The cause of defects was thus found out and the process parameters were improved. |
| |
| Keywords: | Moldflow injection molding flow analysis |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
