首页 | 本学科首页   官方微博 | 高级检索  
     

交流电力测试系统中关键采样点的估计方法研究
引用本文:李世玺,肖继学,王凯. 交流电力测试系统中关键采样点的估计方法研究[J]. 化工自动化及仪表, 2010, 37(9): 42-45,49
作者姓名:李世玺  肖继学  王凯
作者单位:西华大学,机械工程与自动化学院,成都,610039;西华大学,机械工程与自动化学院,成都,610039;西华大学,机械工程与自动化学院,成都,610039
基金项目:四川省教育厅科研基金资助项目 
摘    要:以交流电压为例,分析了交流电力测试系统信号处理中关键采样点对特征参数的影响,提出了关键采样点基于误差最小均方法和拉格朗日插值法的估计方法,指出这些方法能提高测试的抗干扰能力,在不增加额外硬件开销的情况下有效提高测试系统的精确性和可靠性。实验结果表明,采用这些估计方法可减少2倍左右用于分析的采样点数,初始相位角的测试误差减小到原来的25%左右,干扰幅值的要求从小于信号幅值的5%可放宽到信号幅值的15%。

关 键 词:交流电压  采样点  估计

Research on Estimation of Key Sampling Point in AC Power Test System
LI Shi-xi,XIAO Ji-xue,WANG Kai. Research on Estimation of Key Sampling Point in AC Power Test System[J]. Control and Instruments In Chemical Industry, 2010, 37(9): 42-45,49
Authors:LI Shi-xi  XIAO Ji-xue  WANG Kai
Affiliation:(School of Mechanical Engineering and Automation,Xihua University,Chengdu 610039,China)
Abstract:Based on AC voltage,the effect of key sampling data on the parameters of characteristics during the voltage signal processing in AC power test system was analyzed.Estimation methods of key sampling data based on error LMS method and Lagrange interpolation were proposed.It was pointed out that the estimation methods could enhance the anti-jamming capability and improve the accuracy and reliability of the test system effectively without additional hardware overhead.Simulation results show that the estimation methods can reduce number of the sample data for the power analysis by about two times,the test error of the initial phase angle to about 25%,and the noise amplitude can be permitted from less than 5% to 15% of signal amplitude.
Keywords:AC voltage  sample point  estimation
本文献已被 CNKI 维普 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号