| 复杂薄壁微小截面环形件的充液成形技术研究 |
| |
| 引用本文： | 郎利辉,王永铭,段新民,李惠丽.复杂薄壁微小截面环形件的充液成形技术研究[J].锻压技术,2011,36(2):34-38. |
| |
| 作者姓名： | 郎利辉 王永铭 段新民 李惠丽 |
| |
| 作者单位： | 1. 北京航空航天大学机械工程及自动化学院,北京,100191
2. 沈阳黎明航空发动机,集团,有限责任公司饭焊厂,辽宁,沈阳,110043 |
| |
| 摘 要： | 针对具有微小特征尺寸的复杂薄壁环形零件提出了轴向进给与充液胀形相结合的多级充液成形工艺方法.以通用有限元软件ABAQUS为平台建立数值模拟模型,基于建立的模型对复杂环形零件的成形工艺进行模拟,分析了液室压力加载曲线、模具的摩擦系数、开模间距等工艺条件对成形的影响,得出开模间距和液室压力是影响成形结果的主要因素,最终给出...
|
| 关 键 词： | 充液成形 数值模拟 特种材料 微小零件 |
Research on multi-step hydroforming of complicated thin wall circular part with small section |
| |
| LANG Li-hui,WANG Yong-ming,DUAN Xin-min,LI Hui-li.Research on multi-step hydroforming of complicated thin wall circular part with small section[J].Forging & Stamping Technology,2011,36(2):34-38. |
| |
| Authors: | LANG Li-hui WANG Yong-ming DUAN Xin-min LI Hui-li |
| |
| Affiliation: | 1(1.School of Mechanical Engineering and Automation,Beihang University,Beijing 100191,China;2.Shenyang Liming Aero-Engine(Group),Corporation Ltd.,Shenyang 110043,China) |
| |
| Abstract: | The multi-step hydroforming process composed of axial feeding and hydraulic pressure bulging was put forward for the ring shaped part with small feature size,complex figure and thin wall.The numerical simulation model was built by general finite element analysis software-ABAQUS.Simulation about the hydroforming process of complex ring shaped part was implemented based on the numerical modes above.Then the influences of liquid pressure loading curve,the mould friction coefficient,the space between the mould parts,and some other conditions on the formability were analyzed.The results show that the space and the liquid pressure are the main factors.The reasonable matching relation curve between space and pressure was given.This process is certified by experiment |
| |
| Keywords: | hydroforming numerical simulation special materials small part |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
