| 300MN模锻液压机液压变压系统故障仿真研究 |
| |
| 引用本文： | 刘石梅,谭建平,陈晖. 300MN模锻液压机液压变压系统故障仿真研究[J]. 锻压技术, 2011, 36(2): 59-64. DOI: 10.3969/j.issn.1000-3940.2011.02.014 |
| |
| 作者姓名： | 刘石梅 谭建平 陈晖 |
| |
| 作者单位： | 中南大学机电工程学院,湖南,长沙,410083 |
| |
| 基金项目： | 国家高技术研究发展计划(863计划)资助项目 |
| |
| 摘 要： | 针对300 MN模锻液压机实际生产中存在的变压器回程时间过长而无法长行程加压故障,基于AMESim软件建立了变压系统的仿真模型并进行了故障仿真,定量地得到了变压器操纵分配器排水阀开启度与充液罐压力对回程时间的影响规律.推导出变压器发生无法长行程加压故障的条件并将其应用于现场故障分析,结果表明:将凸轮顶杆与排水阀阀杆间隙...
|
| 关 键 词： | 模锻液压机 液压变压器 仿真分析 |
Simulation research on hydraulic transformer system fault of 300 MN die forging hydraulic press |
| |
| LIU Shi-mei,TAN Jian-ping,CHEN Hui. Simulation research on hydraulic transformer system fault of 300 MN die forging hydraulic press[J]. Forging & Stamping Technology, 2011, 36(2): 59-64. DOI: 10.3969/j.issn.1000-3940.2011.02.014 |
| |
| Authors: | LIU Shi-mei TAN Jian-ping CHEN Hui |
| |
| Affiliation: | (School of Mechanical and Electrical Engineering,Central South University,Changsha 410083,China) |
| |
| Abstract: | In order to analyze the fault of hydraulic transformer which failed to work in long-stroke pressurizing because of its too long return time,a simulation model about hydraulic transformer system of 300MN forging hydraulic press was established based on AMESim software.The influence of opening height of drain valves and pressure of liquid-filled tank on the return time of hydraulic transformer was simulated quantitatively.The condition,which would result in fault,was obtained and used to analyze the actual fault.The result shows that the fault can be eliminated through reducing the space between the cam plunger and drain valve stem by 4.6 mm. |
| |
| Keywords: | die forging hydraulic press hydraulic transformer sfystem simulation |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
