Plastic buckling of tubes under axial compression and internal pressure

The plastic buckling and collapse of long cylinders under combined internal pressure and axial compression was investigated through a combination of experiments and analysis. Stainless-steel cylinders with diameter-to-thickness values of 28.3 and 39.8 were compressed to failure at fixed values of internal pressure up to values 75% of the yield pressure. The first effect of internal pressure is a lowering of the axial stress–strain response. In addition, at some plastic strain level, the cylinder develops uniform axisymmetric wrinkling. Under continued compression, the wrinkles grow stably, gradually reducing the axial rigidity of the structure and eventually lead to a limit load instability. All pressurized cylinders remained axisymmetric until the end of the test past the limit load.The critical stress and wavelength were established using classical plastic bifurcation theory based on the deformation theory of plasticity. The evolution of wrinkling, and the resultant limit state, were established by modeling a periodic domain that is one half of the critical wavelength long. The domain was assigned an initial imperfection corresponding to the axisymmetric buckling mode calculated through the bifurcation check. The inelastic material behavior was modeled through the flow theory of plasticity with isotropic hardening. The variations of the axial response and of the limit strain with pressure observed in the experiments were reproduced well by the model. Inclusion of Hill-type anisotropic yielding in all constitutive models was required for good agreement between predictions and experiments.