首页 | 本学科首页   官方微博 | 高级检索  
     


Microstructure and creep behaviour of eutectic SnAg and SnAgCu solders
Authors:S Wiese  K -J Wolter
Affiliation:Dresden University of Technology, Electronic Packaging Laboratory, TU Dresden, Fak. EuI, IAVT, Dresden D-01062, Germany
Abstract:The paper presents creep data, that was gained on specimens of different microstructures. The three specimen types have been flip chip solder joints, pin trough hole solder joints and standard bulk solder specimens. The bulk solder specimen was a dog-bone type specimen (diameter=3 mm, LENGTH=117 mm). The pin trough hole solder joint consisted on a copper wire that was soldered into a hole of a double sided printed circuit board (thickness 1.5 mm). The flip chip solder joint specimen consisted of two silicon chips (4 mm × 4 mm), which were connected by four flip chip joints (one on each corner). SnAg and SnAgCu flip chip bumps (footprint 200 μm × 200 μm, joint height 165–200 μm, centre diameter 90…130 μm) were created by printing solder paste.Constant–load creep tests were carried out on all three specimen types at temperatures between 5 and 70 °C. Creep data was taken for strain rates between 10−10 and 10−3 s−1. The specimens were tested in “as cast” condition and after thermal storage.The microstructural properties of the bulk specimens and real solder joints were examined using metallographic sectioning, optical microscopy techniques, and SEM-microprobe analysis. The results of the microstructural analysis were related to the investigated mechanical properties of the solders. Models of SnAg3.5 and SnAg4Cu0.5, that can be used with the ANSYS FEM software package, will be presented.
Keywords:
本文献已被 ScienceDirect 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号