| 浅谈注塑件的成型缩痕 |
| |
| 引用本文： | 顾胜益. 浅谈注塑件的成型缩痕[J]. 工程塑料应用, 1996, 24(3): 26-28 |
| |
| 作者姓名： | 顾胜益 |
| |
| 作者单位： | 西湖电子集团注塑模具厂 杭州 |
| |
| 摘 要： | 分析注塑件产生缩痕的原因，并从成型工艺角度出发提出解决缩痕的对策。
|
| 关 键 词： | ABS树脂 缩痕 成型工艺 塑料件 注塑件 注射成型 |
INTRODUCTION OF THE SINK-MARK OF INJECTION MOLDING |
| |
| Gu Shengyi. INTRODUCTION OF THE SINK-MARK OF INJECTION MOLDING[J]. Engineering Plastics Application, 1996, 24(3): 26-28 |
| |
| Authors: | Gu Shengyi |
| |
| Affiliation: | Plastics Mold Factory of West Lake Electronic Corp.Hangzhou 310021 |
| |
| Abstract: | This article analyzes the reason of the sink-mark on injection molding product,and raise the solution about this question from view point of molding technology. |
| |
| Keywords: | television plastic cover ABS resin sink-mark. molding technology |
| 本文献已被 CNKI 维普 等数据库收录！ |
