| Abstract: | In this study,Zr41.2Ti13.8Cu12.5Ni10Be22.5 amorphous alloys samples with the same diameter(8 mm)were prepared by using self-designed molds(viz.refractory steel,pure graphite,and copper molds)with dif-ferent cooling capacities.Moreover,by eliminating the size effect,the effect of the cooling rate on the microstructure and compression deformation behavior of Zr41.2Ti13.8Cu12.5Ni10Be22.5 amorphous alloys was investigated.Differentiation of the cooling curves revealed that the instantaneous cooling rates of the alloy melt at the glass transition temperature(Tg)are 45,52,and 64K·s-1 for refractory steel,pure graphite,and copper molds,respectively.X-ray diffraction,differential scanning calorimetry,and high-resolution transmission electron microscopy analysis revealed that with the decrease in the cooling rate,trace icosahedral-like atomic clusters and nanocrystals appear in local areas of the amorphous alloy and that the amount of free volume decreases with the increase in the amount of icosahedra-like atomic clusters and nanocrystals.Compression test results revealed that the elastic strain,yield strength,and compressive strength of the amorphous alloy marginally change with the decrease in the cooling rate,while the plastic strain gradually increases.By fitting,the effective size of the vein-like pattern was lin-early related to the enthalpy released during structural relaxation and plastic strain,indicating that at a low cooling rate,the trace nanocrystals in the amorphous alloy could not effectively improve its plasticity and that the amount of free volume mainly affects its plasticity. |
