| 汽车前底板冲压工艺分析与拉深模设计 |
| |
| 引用本文： | 郑晖,于利凯.汽车前底板冲压工艺分析与拉深模设计[J].锻压技术,2009,34(3). |
| |
| 作者姓名： | 郑晖 于利凯 |
| |
| 作者单位： | 1. 东北大学,轧制技术及连轧自动化国家重点实验室,辽宁,沈阳,110004;沈阳航空工业学院航宇学院,辽宁,沈阳,110136
2. 沈阳航空工业学院航宇学院,辽宁,沈阳,110136 |
| |
| 摘 要： | 在分析汽车前底板结构和工艺特点的基础上,确定了零件的成形工序,应用AUTOFORM V3.22软件对工艺方案进行了优化,以UG为辅助工具,设计出拉深成形所需的凸模、凹模以及压边圈,对于模具零部件装配,得到拉深模具的装配体三维数模.同时,介绍了覆盖件拉深模结构设计要点.通过实践验证,设计的拉深模工艺性良好、结构合理、符合生产要求.
|
| 关 键 词： | 冲压工艺 覆盖件 拉深模 三维建模 |
Analysis of stamping technology and design of drawing die for car front floor boarding |
| |
| ZHENG Hui,YU Li-kai.Analysis of stamping technology and design of drawing die for car front floor boarding[J].Forging & Stamping Technology,2009,34(3). |
| |
| Authors: | ZHENG Hui YU Li-kai |
| |
| Affiliation: | 1.State Key Laboratory of Rolling and Automation;Northeastern University;Shenyang 110004;China;2.School of Aerospace Engineering;Shenyang Institute of Aeronautical Engineering;Shenyang 110136; |
| |
| Abstract: | The forming process of car front floor boarding was planned based on the analysis on its structure and technological characteristic. AUTOFORM V3.22 software was used to optimize the technological process. The punch,die and the blank holder for the drawing die were designed by using UG. They were assembled and the three-dimensional modeling of drawing die was generated. Then the design points of the die structure were stated. It is proved by experience that the process property of the die is fine and the str... |
| |
| Keywords: | stamping technology auto panel drawing die three-dimensional modeling |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
