A spatial kinetic model for simulating VVER-1000 start-up transient

An accurate prediction of reactor core behavior in transients depends on how much it could be possible to exactly determine the thermal feedbacks of the core elements such as fuel, clad and coolant. In short time transients, results of these feedbacks directly affect the reactor power and determine the reactor response. Such transients are commonly happened during the start-up process which makes it necessary to carefully evaluate the detail of process. Hence this research evaluates a short time transient occurring during the start up of VVER-1000 reactor. The reactor power was tracked using the point kinetic equations from HZP state (100 W) to 612 kW. Final power (612 kW) was achieved by withdrawing control rods and resultant excess reactivity was set into dynamic equations to calculate the reactor power. Since reactivity is the most important part in the point kinetic equations, using a Lumped Parameter (LP) approximation, energy balance equations were solved in different zones of the core. After determining temperature and total reactivity related to feedbacks in each time step, the exact value of reactivity is obtained and is inserted into point kinetic equations. In reactor core each zone has a specific temperature and its corresponding thermal feedback. To decrease the effects of point kinetic approximations, these partial feedbacks in different zones are superposed to show an accurate model of reactor core dynamics. In this manner the reactor point kinetic can be extended to the whole reactor core which means “Reactor spatial kinetic”. All required group constants in calculations are prepared using the WIMS code. In addition CITATION code was used to calculate the flux, power distribution and core reactivity inside the core. To update the last change in group constants and resultant reactivity in point kinetic equations, these neutronic codes were coupled with a developed dynamic program. This study is applied on a typical VVER-1000 reactor core to show the reactor response in short time transients caused during start-up procedure.