Effects of fuel compositions on the heat generation and emission of syngas/producer gas laminar diffusion flame |
| |
| Affiliation: | 1. Department of Biotechnology, MNNIT Allahabad, Prayagraj 211004, U.P., India;2. Department of Chemistry, MNNIT Allahabad, Prayagraj 211004, U.P., India;1. Chemical Engineering Program, Texas A and M University at Qatar, P.O. Box 23874, Doha, Qatar;2. Artie McFerrin Department of Chemical Engineering, Texas A and M University, MS 3122, College Station, TX, 77843-3122, United States;3. Catalysis Institute and c*change (DST-NRF Centre for Excellence in Catalysis), Department of Chemical Engineering, University of Cape Town, Cape Town, South Africa;4. Department of Chemical Engineering, Aristotle University of Thessaloniki, University Campus, 54124, Thessaloniki, Greece;5. Chemical Process & Energy Resources Institute (CPERI), Centre for Research and Technology Hellas (CERTH), 6th km Charilaou - Thermi Road, P.O. Box 361, 57001, Thessaloniki, Greece;1. Dipartimento di Ingegneria Chimica, dei Materiali e della Produzione Industriale, University of Naples Federico II Naples, 80125, Italy;2. Institute for Researches on Combustion-CNR, Naples, 80125, Italy;3. CSGI, Center for Colloid and Surface Science, Florence, 50019, Italy;4. Department of Applied Science and Technology, Politecnico di Torino, Torino, 10129, Italy;1. Institute for Water and Wastewater Technology, Durban University of Technology, Durban, 4000, South Africa;2. Sanitary Engineering Department, Alexandria University, Alexandria, 21544, Egypt;3. Department of Chemical Engineering, Durban University of Technology, Durban, 4000, South Africa |
| |
| Abstract: | Demand for the clean and sustainable energy encourages the research and development in the efficient production and utilisation of syngas for low-carbon power and heating/cooling applications. However, diversity in the chemical composition of syngas, resulting due to its flexible production process and feedstock, often poses a significant challenge for the design and operation of an effective combustion system. To address this, the research presented in this paper is particularly focused on an in-depth understanding of the heat generation and emission formation of syngas/producer gas flames with an effect of the fuel compositions. The heat generated by flame not only depends on the flame temperature but also on the chemistry heat release of fuel and flame dimension. The study reports that the syngas/producer gas with a low H2:CO maximises the heat generation, nevertheless the higher emission rate of CO2 is inevitable. The generated heat flux at H2:CO = 3:1, 1:1, and 1:3 is found to be 222, 432 and 538 W m-2 respectively. At the same amount of heat generated, H2 concentration in fuel dominates the emission of NOx. The addition of CH4 into the syngas/producer gas with H2:CO = 1:1 also increases the heat generation significantly (e.g. 614 W m-2 at 20%) while decreases the emission formation. In contrast, adding 20% CO2 and N2 to the syngas/producer gas composition reduces the heat generation from 432 W m-2 to 364 and 290 W m-2, respectively. The role of CO2 on this aspect, which is weaker than N2, thus suggests CO2 is preferable than N2. Along with the study, the significant role of CO2 on the radiation of heat and the reduction of emission are examined. |
| |
| Keywords: | Syngas/producer gas Syngas combustion Laminar diffusion flame Combustion modelling Heat generation Emission |
| 本文献已被 ScienceDirect 等数据库收录！ |
|
