| 大型铝合金薄壁件低压铸造工艺研究 |
| |
| 引用本文： | 余瑾,杨天云,杨兵,马谷剑.大型铝合金薄壁件低压铸造工艺研究[J].特种铸造及有色合金,2011,31(10):935-938. |
| |
| 作者姓名： | 余瑾 杨天云 杨兵 马谷剑 |
| |
| 作者单位： | 合肥工业大学材料科学与工程学院 |
| |
| 摘 要： | 采用有限元模拟仿真软件结合正交试验方法,对铝合金汽车座椅骨架低压铸造工艺进行数值模拟,研究了低压铸造加压工艺参数对铸件缩松、缩孔、充型及凝固规律的影响。结果表明,当充型时间为1.5s、增压压力为7kPa及保压时间为100s时,铸件缩孔、缩松率最小,且成形质量最佳。
|
| 关 键 词： | 铝合金 低压铸造 正交试验 数值模拟 充型凝固 |
Low Pressure Casting Large Thin-Walled Aluminum Alloy Parts |
| |
| Yu Jin,Yang Tianyun,Yang Bing,Ma Guiian.Low Pressure Casting Large Thin-Walled Aluminum Alloy Parts[J].Special Casting & Nonferrous Alloys,2011,31(10):935-938. |
| |
| Authors: | Yu Jin Yang Tianyun Yang Bing Ma Guiian |
| |
| Affiliation: | Yu Jin,Yang Tianyun,Yang Bing,Ma Gujian(School of Material Science and Engineering,Hefei University of Technology) |
| |
| Abstract: | Filling and solidification in low pressure casting aluminum alloy automobile seat frame were simulated by FEM(finite element method) combining with orthogonal testing to understand effects of processing parameters on shrinkage porosity(hole) ,filling and solidification. The results show that the minimum shrinkage porosity(hole) rate in the low pressure casting aluminum alloy seat frame can be observed with desirable appearance quality when filling time is 1.5s with holding-pressure of 7kPa and holding-press... |
| |
| Keywords: | Aluminum Alloy Low Pressure Casting Orthogonal Testing Numerical Simulation Filling and Solidification |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
