Experimental and post-test calculation results of the integral reflood test QUENCH-12 with a VVER-type bundle

The QUENCH-12 experiment was carried out to investigate the effects of VVER materials (niobium-bearing alloys) and bundle geometry on core reflood, in comparison with test QUENCH-06 using western PWR materials (Zircaloy-4) and bundle geometry. The test protocol involved pre-oxidation to a maximum of about 150 μm oxide thickness at a temperature of about 1450 K, followed by a power ramp until a temperature of 2050 K was reached, then reflood with water at room temperature was initiated. The total hydrogen production was 58 g (QUENCH-06: 36 g), 24 g of which were released during reflood (QUENCH-06: 4 g). Reasons for the increased hydrogen production may be extensive damaging of the cladding surfaces due to the breakaway oxidation and local melt formation with subsequent melt oxidation. Post-test videoscope observations and metallographic investigations showed an influence of the breakaway oxidation with extensive spalling of oxide scales of rod claddings, shroud and auxiliary corner rods. The hydrogen content in the corner rods, withdrawn from the bundle during the test, reached more than 30 at% at the bundle elevations of 850 and 1100 mm. Post-test calculations were performed with local versions of SCDAP/RELAP5 following on from pre-test analyses with SCDAP/RELAP5 and SCDAPSIM.