| 内高压成形三台阶轴过程中内压值影响的有限元分析 |
| |
| 引用本文： | 李洪洋,苑世剑,王小松,苗启斌,王仲仁.内高压成形三台阶轴过程中内压值影响的有限元分析[J].塑性工程学报,2005,12(2):38-41,93. |
| |
| 作者姓名： | 李洪洋 苑世剑 王小松 苗启斌 王仲仁 |
| |
| 作者单位： | 1. 清华大学,机械工程系,北京,100084
2. 哈尔滨工业大学,材料科学与工程学院,哈尔滨,150001 |
| |
| 基金项目： | 国家自然科学基金项目(59975021) |
| |
| 摘 要： | 以内高压成形台阶轴过程中压力参数的影响为研究目标,利用大变形非线性塑性有限元方法对成形零件的壁厚和应变分布规律进行了探索。给出了不同内压条件下零件的壁厚及应变分布,并就内压对成形的影响进行了讨论。分析了不同压力对起皱和减薄等缺陷的影响,并在此基础上给出了相应的实验结果。分析结果表明,内压值的选取对内高压成形台阶轴具有重要影响,对文中台阶轴来说,30MPa的压力值是成形的最佳压力。
|
| 关 键 词： | 内高压成形 台阶轴 内压 有限元 |
| 文章编号： | 1007-2012(2005)02-0038-04 |
| 修稿时间： | 2004年6月10日 |
The analyzing of internal pressure effect of hydroforming three-diameter shaft by FEM |
| |
| Li Hongyang,YUAN Shijian,Wang Xiaosong,MIAO Qibin,WANG Zhongren.The analyzing of internal pressure effect of hydroforming three-diameter shaft by FEM[J].Journal of Plasticity Engineering,2005,12(2):38-41,93. |
| |
| Authors: | Li Hongyang YUAN Shijian Wang Xiaosong MIAO Qibin WANG Zhongren |
| |
| Abstract: | To explore the influence of internal pressure on hydroforming three-diameter shaft, the procedure of hydroforming shaft was simulated by FEM in this paper. The corresponding thickness distribution and strain distribution of different pressure was given out, the effect of the pressure on the simulation result was discussed and the destabilization format of wrinkle and thickness reduction was analyzed. Base on the simulation result, corresponding experimental result was also presented. The analyzing show that the selection of pressure have a strong influence on hydorforming three-diameter shaft and for the shaft of this paper 30MPa is the best pressure parameter. |
| |
| Keywords: | tube hydroforming multi-diameter shaft internal pressure FEM |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
