3D modeling of anode-supported planar SOFC with internal reforming of methane |
| |
Authors: | Kasra Nikooyeh Ayodeji A. JejeJosephine M. Hill |
| |
Affiliation: | Department of Chemical and Petroleum Engineering, University of Calgary, 2500 University Dr NW, Calgary, Alberta T2N 1N4, Canada |
| |
Abstract: | Deposition of carbon on conventional anode catalysts and formation of large temperature gradients along the cell are the main barriers for implementing internal reforming in solid oxide fuel cell (SOFC) systems. Mathematical modeling is an essential tool to evaluate the effectiveness of the strategies to overcome these problems. In the present work, a three-dimensional model for a planar internal reforming SOFC is developed. A co-flow system with no pre-reforming, methane fuel utilization of 75%, voltage of 0.7 V and current density of 0.65 A cm−2 was used as the base case. The distributions of both temperature and gas composition through the gas channels and PEN (positive electrode/electrolyte/negative electrode) structure were studied using the developed model. The results identified the most susceptible areas for carbon formation and thermal stress according to the methane to steam ratio and temperature gradients, respectively. The effects of changing the inlet gas composition through recycling were also investigated. Recycling of the anode exhaust gas, at an optimum level of 60% for the conditions studied, has the potential to significantly decrease the temperature gradients and reduce the carbon formation at the anode, while maintaining a high current density. |
| |
Keywords: | SOFC Direct internal reforming Methane Anode-supported Recycling |
本文献已被 ScienceDirect 等数据库收录! |
|