Procedural influence on the properties of particleboards made from AKD modified chips

Wood chips were treated with alkyl ketene dimer (AKD) using three different processes to impart water resistance to particleboards. In the first process, AKD was blended with UF resin. Thickness swelling and water uptake after a 24 h immersion period (20 and 69%) were lower than in the control boards (28 and 81%) but were higher than in the paraffin references (10 and 22%). In process 2, AKD and UF resin were sprayed separately on the chips resulting in a greater reduction of thickness swelling (15%) and water uptake (49%) than in process 1. Paraffin references revealed a thickness swelling and water uptake of 7 and 25%, respectively. An extension of the pressing time in processes 1 and 2 did not increase water repellence. In process 3, particleboards were made from AKD-treated chips that were cured at 130 °C (24 h) prior to gluing. They showed a thickness swelling of 7% and a water uptake of 25%, whereas particleboards with paraffin exhibited levels of 8 and 29%. The thickness swelling and water uptake of boards with AKD increased when the curing time was reduced from 24 to 12 to 6 h (130 °C). Changing the curing temperature from 130 to 100 °C (12 h) had no effect on board properties. The IB of boards made from pre-cured chips with AKD (24 h/130 °C) was 44% lower than in controls and 35% lower than in paraffin references. This indicates that AKD impedes the adhesion.