| 斯特林发动机V型传动系统激励力的计算分析研究 |
| |
| 引用本文： | 缪斯浩,周建明,杨欣,孙思聪,周晟.斯特林发动机V型传动系统激励力的计算分析研究[J].柴油机,2018,40(6):43-48. |
| |
| 作者姓名： | 缪斯浩 周建明 杨欣 孙思聪 周晟 |
| |
| 作者单位： | 武汉理工大学能源与动力工程学院，湖北 武汉 430063,七一一研究所, 上海 201203,七一一研究所, 上海 201203,武汉理工大学能源与动力工程学院，湖北 武汉 430063,七一一研究所, 上海 201203 |
| |
| 基金项目： | 受上科委科研计划项目资助（16DZ1203200）。 |
| |
| 摘 要： | 介绍了有关斯特林发动机传动系统激励力的计算分析研究。建立了斯特林发动机传动系统刚柔混合的多体动力学模型，计算了曲轴主轴承载荷和活塞侧推力等激励力。对比分析了有、无齿轮啮合力对主轴承载荷的影响，指出:计算斯特林发动机传动系统激励力时应考虑齿轮啮合冲击力的影响。对比分析了不同活塞间隙对活塞侧推力的影响，结果表明:活塞杆与缸套间隙在0.08~0.12 mm时，活塞侧推力的影响较小。
|
| 关 键 词： | 激励力 传动系统 斯特林发动机 齿轮啮合 |
| 收稿时间： | 2018/1/25 0:00:00 |
| 修稿时间： | 2018/3/6 0:00:00 |
Calculation Analysis of Motivating Forces of V-TypeTransmission Systems for Stirling Engines |
| |
| Miu Sihao,Zhou Jianming,Yang Xin,Sun Sicong and Zhou Sheng.Calculation Analysis of Motivating Forces of V-TypeTransmission Systems for Stirling Engines[J].Diesel Engine,2018,40(6):43-48. |
| |
| Authors: | Miu Sihao Zhou Jianming Yang Xin Sun Sicong and Zhou Sheng |
| |
| Abstract: | The calculation analysis of the motivating forces of the transmission system for a Stirling Engine is introduced. The rigid and flexible dynamical model of the transmission system of the Stirling engine was built. The motivating force or the bearing load of crank shaft and the piston side thrust were calculated. The influence of with or without gear meshing force on the main bearing load were compared with each other and analyzed. The impact of the gear meshing impact should be considered in the analysis of the transmission system of the Stirling engine. Comparison analysis of the influences of the different piston clearances on the piston thrust was conducted, and the results showed that when the clearance between the piston rod and cylinder liner was 0.08~0.12 mm, the influence was smaller. |
| |
| Keywords: | motivating force transmission system Stirling engine gear meshing |
|
| 点击此处可从《柴油机》浏览原始摘要信息 |
|
点击此处可从《柴油机》下载全文 |
|
