首页 | 本学科首页   官方微博 | 高级检索  
     

雾化喷涂沉积对晶界扩散Nd-Fe-B磁性能和微观结构的影响
引用本文:刁树林,罗阳,彭海军,林笑,董义,伊海波,吴树杰,张帅,于敦波.雾化喷涂沉积对晶界扩散Nd-Fe-B磁性能和微观结构的影响[J].稀有金属材料与工程,2022,51(10):3638-3645.
作者姓名:刁树林  罗阳  彭海军  林笑  董义  伊海波  吴树杰  张帅  于敦波
作者单位:有研科技集团有限公司 稀土材料国家工程研究中心,北京 100088;有研稀土新材料股份有限公司,北京 100088;北京有色金属研究总院,北京 100088;包头天和磁材科技股份有限公司,内蒙古 包头 014010,有研科技集团有限公司 稀土材料国家工程研究中心,北京 100088;有研稀土新材料股份有限公司,北京 100088;北京有色金属研究总院,北京 100088,有研科技集团有限公司 稀土材料国家工程研究中心,北京 100088;有研稀土新材料股份有限公司,北京 100088;北京有色金属研究总院,北京 100088,有研科技集团有限公司 稀土材料国家工程研究中心,北京 100088;有研稀土新材料股份有限公司,北京 100088;北京有色金属研究总院,北京 100088,包头天和磁材科技股份有限公司,内蒙古 包头 014010,包头天和磁材科技股份有限公司,内蒙古 包头 014010,包头天和磁材科技股份有限公司,内蒙古 包头 014010,包头天和磁材科技股份有限公司,内蒙古 包头 014010,有研科技集团有限公司 稀土材料国家工程研究中心,北京 100088;有研稀土新材料股份有限公司,北京 100088;北京有色金属研究总院,北京 100088
基金项目:北京市青年拔尖团队支持项目(批准号:2018000021223TD10)、河北省重大科技成果转化基金(批准号:19041029Z)、河北省国际科技合作基地建设项目(批准号:20591002D)资助
摘    要:提出了一种新的雾化喷涂沉积(SCD)方法,在Nd-Fe-B磁体表面均匀沉积TbF3粉末,同时通过晶界扩散过程(GBDP)将Tb元素引入到磁体中。用这种方法(SCD+GBDP)处理厚度达5 mm的钕铁硼磁体。研究了TbF3涂层增重比、扩散时间和扩散温度对烧结磁体组织和磁性能的影响。样品扩散温度和时间为940 ℃和10 h,退火温度和时间为480 ℃和5 h。TbF3增重比(w)从0%增加到0.8%时,磁体的矫顽力从1201 kA/m 提高到1930 kA/m,剩磁下降约0.01 T。研究发现,随着TbF3增重比的增加,磁体的矫顽力先增大后减小。SEM结果表明,在Nd2Fe14B晶粒边界区域,Tb取代Nd形成(Nd, Tb)2Fe14B核壳相。晶界相和核壳相中较高的磁晶各向异性对矫顽力的增强有积极的促进作用。核壳相的分布和浓度对矫顽力有密切的影响。当TbF3增重比大于2.4%时,靠近磁体表面区域的晶界扩散明显增强。元素的SEM图像显示,进入磁体的Tb越多,晶核内的Tb浓度就越高。此外,大量Nd-F/Nd-O-F相的形成导致晶界相不像w=0.8% 时的样品那样连续,这可能是导致矫顽力下降的主要原因。

关 键 词:烧结钕铁硼磁体  雾化喷涂  晶界扩散  磁性能
收稿时间:2021/9/14 0:00:00
修稿时间:2022/10/10 0:00:00

Influence of Spray Coating Deposition on Magnetic Properties and Microstructure of Grain Boundary Diffusion Nd-Fe-B Magnets
Diao Shulin,Luo Yang,Peng Haijun,Lin Xiao,Dong Yi,Yi Haibo,Wu Shujie,Zhang Shuai and Yu Dunbo.Influence of Spray Coating Deposition on Magnetic Properties and Microstructure of Grain Boundary Diffusion Nd-Fe-B Magnets[J].Rare Metal Materials and Engineering,2022,51(10):3638-3645.
Authors:Diao Shulin  Luo Yang  Peng Haijun  Lin Xiao  Dong Yi  Yi Haibo  Wu Shujie  Zhang Shuai and Yu Dunbo
Affiliation:National Engineering Research Center for Rare Earth Materials, GRINM Group Co., Ltd, Beijing 100088, China;GRIREM Advanced Materials Co., Ltd, Beijing 100088, China;General Research Institute for Nonferrous Metals, Beijing 100088, China;Baotou Tianhe Magnetics Technology Co., Ltd, Baotou 014010, China,National Engineering Research Center for Rare Earth Materials, GRINM Group Co., Ltd, Beijing 100088, China;GRIREM Advanced Materials Co., Ltd, Beijing 100088, China;General Research Institute for Nonferrous Metals, Beijing 100088, China,National Engineering Research Center for Rare Earth Materials, GRINM Group Co., Ltd, Beijing 100088, China;GRIREM Advanced Materials Co., Ltd, Beijing 100088, China;General Research Institute for Nonferrous Metals, Beijing 100088, China,National Engineering Research Center for Rare Earth Materials, GRINM Group Co., Ltd, Beijing 100088, China;GRIREM Advanced Materials Co., Ltd, Beijing 100088, China;General Research Institute for Nonferrous Metals, Beijing 100088, China,Baotou Tianhe Magnetics Technology Co., Ltd, Baotou 014010, China,Baotou Tianhe Magnetics Technology Co., Ltd, Baotou 014010, China,Baotou Tianhe Magnetics Technology Co., Ltd, Baotou 014010, China,Baotou Tianhe Magnetics Technology Co., Ltd, Baotou 014010, China,National Engineering Research Center for Rare Earth Materials, GRINM Group Co., Ltd, Beijing 100088, China;GRIREM Advanced Materials Co., Ltd, Beijing 100088, China;General Research Institute for Nonferrous Metals, Beijing 100088, China
Abstract:A novel method of spray coating deposition (SCD) was proposed to deposit TbF3 powder solution uniformly onto the surface of Nd-Fe-B magnets, and then the Tb element was introduced into the magnets through the grain boundary diffusion process (GBDP). Nd-Fe-B magnets with thickness up to 5 mm were treated with this method (SCD+GBDP). The effects of mass gain ratio (w) of TbF3 coatings, diffusion time and the diffusion temperature on the microstructure and magnetic properties of the sintered magnets were investigated. The samples were diffused at 940 °C for 10 h and then annealed at 480 °C for 5 h. Results show that when the TbF3 mass gain ratio increases from 0% to 0.8%, the coercivity of the magnets increases from 1201 to 1930 kA/m and the remanence is only decreased by 0.01 T. With increasing the mass gain ratio of TbF3, the coercivity of the magnets increases firstly and then decreases obviously. SEM results show that the (Nd, Tb)2Fe14B core-shell phases can be formed by Tb which replaces the Nd in the boundary region among Nd2Fe14B grains. The improved decoupling effect by the continuous grain boundary phase and the higher magnetocrystalline anisotropy of the core-shell phase plays a positive role in the coercivity enhancement. The distribution and concentration of core-shell phase have a close influence on the coercivity. When the TbF3 mass gain ratio is more than 2.4%, the grain boundary diffusion is obviously enhanced in the region close to the magnet surface. The SEM image of the element shows that the more Tb enters the inside of the grain, the higher the Tb concentration in the core than in the shell. Furthermore, the formation of a large amount of Nd-F/Nd-O-F phase causes the grain boundary phase not being as continuous as that of the sample with w=0.8%, which may be the main reason for the decrease in coercivity.
Keywords:sintered Nd-Fe-B magnets  spray coating deposition  grain boundary diffusion process (GBDP)  magnetic properties
点击此处可从《稀有金属材料与工程》浏览原始摘要信息
点击此处可从《稀有金属材料与工程》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号