首页 | 本学科首页   官方微博 | 高级检索  
     

一种全桥式高功率放大器
引用本文:付继伟,杜亮.一种全桥式高功率放大器[J].声学技术,2015,34(5):472-476.
作者姓名:付继伟  杜亮
作者单位:中国船舶重工集团公司第710研究所, 湖北宜昌 443003;中国船舶重工集团公司第710研究所, 湖北宜昌 443003
基金项目:国家863计划项目(2007AA09Z204)
摘    要:用集成功率放大器驱动大功率三极管构成推挽功率放大器,两路推挽功率放大单元可以组合构成全桥式功率放大器,这种放大器大量使用大功率三极管等分立元件,能够提高电路总的额定功率,并且使元件布局分散有利于实现散热设计,工程样机研制证明该方法适用。水库测试结果表明:驱动某大型双谐振压电陶瓷换能器,功放样机输出连续信号时,在5 k Hz左右输出电功率达到1600 W以上。单频信号工作时观察信号波形,信号畸变与失真较小。根据试验与测试结果分析了末级三极管上的功率耗散情况,验证了工程样机在散热设计方面的有效性。

关 键 词:推挽功率放大器  全桥式功率放大器  散热设计
收稿时间:2014/9/4 0:00:00
修稿时间:2014/12/8 0:00:00

A kind of high power full bridge amplifier circuit
FU Ji-wei and DU Liang.A kind of high power full bridge amplifier circuit[J].Technical Acoustics,2015,34(5):472-476.
Authors:FU Ji-wei and DU Liang
Affiliation:Yichang Research institute of Testing Technique, Yichang 443003, Hubei, China;Yichang Research institute of Testing Technique, Yichang 443003, Hubei, China
Abstract:The push-pull power amplifier is formed by integrated power amplifier and high-power transistor. Two push-pull power amplifier circuits can be used to design half bridge amplifier. This kind of amplifiers use lots of power transistors, and this is useful to improve mean power. Layout of the components is also critical to thermal design. Results indicate that the method is available in engineering applications. Test results in reservoir demonstrate that: to drive piezoelectric transducer, the output power of the amplifier reaches 1600 W at 5 kHz. Waveform at a single frequency is slightly distorted. By analyzing the dissipation power of the transistor base on the test result, it is demonstrated that the thermal design is effective.
Keywords:push-pull power amplifier  half bridge amplifier  thermal design
本文献已被 CNKI 万方数据 等数据库收录!
点击此处可从《声学技术》浏览原始摘要信息
点击此处可从《声学技术》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号