首页 | 本学科首页   官方微博 | 高级检索  
     

基于ANSYS的拱架式贴片机整机动力学建模与模态分析
引用本文:李清国,肖曙红,汤雄,陈小军.基于ANSYS的拱架式贴片机整机动力学建模与模态分析[J].机电工程技术,2012(7):72-75.
作者姓名:李清国  肖曙红  汤雄  陈小军
作者单位:广东工业大学机电工程学院,广东广州,510006
摘    要:贴片机工作速度快,效率高,其动态性能对芯片的贴装精度影响大。首先建立贴片机的三维有限元模型,然后利用AN SYS对拱架式贴片机PS1000的整机进行了动力学建模与模态分析。通过对低阶模态分析发现,低阶固有频率与整机的工作频率较为接近,容易产生共振,机架和横梁容易产生平移振动,影响贴装精度,故应该适当提高贴片机的工作频率或提高机架和横梁的刚性,以避免共振区域。最后,采用LMS振动测试仪对样机进行锤击法模态测量,进行了样机的实验模态分析,验证了ANSYS模态分析的可靠性。

关 键 词:贴片机  模态分析  建模

The Dynamic Modeling and Modal Analysis of the Arch Frame Placement Machine Based on ANSYS
LI Qing-guo , XIAO Shu-hong , TANG Xiong , CHEN Xiao-jun.The Dynamic Modeling and Modal Analysis of the Arch Frame Placement Machine Based on ANSYS[J].Mechanical & Electrical Engineering Technology,2012(7):72-75.
Authors:LI Qing-guo  XIAO Shu-hong  TANG Xiong  CHEN Xiao-jun
Affiliation:(Faculty of Mechanical & Electronic Engineering,Guangdong University of Technology,Guangzhou510006,China)
Abstract:The arch frame placement machine is working fast and high efficiency.The dynamic performance of the machine effects on the pasted accuracy of the chip significantly.Firstly,three-dimensional finite element dynamic model of the placement machine is established and model analysis on the whole arch frame is done.The low order natural frequencies and vibration modes are obtained.Based on the result,the low order natural frequency is close to the working frequency in the placement machine.In this situation,the machine is easy to produce big resonance.At the same time,the frame and the crossbeam is easy to generate translation vibration.It is necessary to increase the working frequency or improve the dynamic rigidity of the frame and crossbeam so as to avoid resonance region.Lastly,LMS-vibration-test is used to measure the prototype machine’s modal analysis by hammering on it,test and verify the model analysis of FEM.
Keywords:placement machine  modal analysis  modeling
本文献已被 CNKI 维普 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号