首页 | 本学科首页   官方微博 | 高级检索  
     

DSP最小应用系统的设计
引用本文:刘志刚,黄峰.DSP最小应用系统的设计[J].电子工程师,2006,32(2):33-36.
作者姓名:刘志刚  黄峰
作者单位:解放军理工大学气象学院,江苏省,南京市,211101
摘    要:介绍了基于DSP(数字信号处理)的最小应用系统的整体设计过程。系统采用TMS320VC5402作为主控芯片;ADC0809完成数据的采样及A/D转换,通过TMS320VC5402处理后,由DAC0832完成D/A转换并输出;外部存储器采用通用EPROM,TMS320VC5402采用8位并行EPROM引导方式;并加入了标准的14针JTAG接口,便于系统的调试与仿真。

关 键 词:DSP(数字信号处理)  JTAG  并行引导  引导表
收稿时间:2005-08-11
修稿时间:2005-11-08

Design of Minimum Application System for Digital Signal Processing
Liu Zhigang,Huang Feng.Design of Minimum Application System for Digital Signal Processing[J].Electronic Engineer,2006,32(2):33-36.
Authors:Liu Zhigang  Huang Feng
Affiliation:College of Meteorology, PLA University of Science and Technology, Nanjing 211101, China
Abstract:This paper introduces the overall design of minimum application system for digital signal processing.The system employs TMS320VC5402 as main control chip,ADC0809 samples the analog signals and converts them to digital signals,then after processing of TMS320VC5402,DAC0832 converts the digital signals to analog ones and finally outputs.The system uses general EPROM for the external storage.Besides,the system incorporates a standard 14 pin JTAG interface to debug and simulate.
Keywords:DSP  JTAG  parallel boot  boot table  
本文献已被 CNKI 维普 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号