Analysis of alloying systems of clad stamping tools for cold deformation of metal (review) |
| |
| Authors: | V V Chigarev D M Golub |
| |
| Affiliation: | 1. Priazovskyi State Technical University, Mariupol, Ukraine;2. Donbas State Engineering Academy, Kramatorsk, Ukraine |
| |
| Abstract: | Two alloying systems of stamping tools (with intermetallic and carbide hardening) are analysed. Analysis shows the high characteristics of the metal with different alloying systems. The heat resistance of the 100Kh4M5F2(Zr) alloy is not inferior to the R18 high-speed tool steel, and the hardness equals 58–62 HRC as a result of carbide hardening. The relative wear resistance of the 8Kh4GSV2M5F2T alloy was (ε = 2.65), impact toughness (0.28 MJ/m2) and hardness (55 HRC). The highest wear resistance was recorded for the K15M15N5Kh3B2 alloy with the following properties after heat treatment: impact toughness (0.1 MJ/m2) and hardness (39 HRC). The wear resistance is 2–2.5 times higher than that of the R18 high-speed tool steel and 6–6.5 times higher than that of Cr12 and Cr12Mo steels. |
| |
| Keywords: | Intermetallic hardening carbide hardening flux-cored wire surfacing heat resistance wear resistance hardness toughness |
|
|
