| 镁合金转向器铸件真空压铸过程的模拟研究 |
| |
| 引用本文： | 饶磊,朱炼兵,刘勇,胡启耀. 镁合金转向器铸件真空压铸过程的模拟研究[J]. 特种铸造及有色合金, 2012, 32(7): 637-640 |
| |
| 作者姓名： | 饶磊 朱炼兵 刘勇 胡启耀 |
| |
| 作者单位： | 1. 河海大学机电学院;南昌大学机电工程学院
2. 南昌大学机电工程学院 |
| |
| 基金项目： | 国家自然科学基金资助项目，国家科技支撑计划资助项目 |
| |
| 摘 要： | 针对汽车镁合金转向器铸件,采用数值模拟的方法研究了其真空压铸成形过程,分析了在高真空度条件下金属液充型的特点,并在此基础上对比研究了在高真空度、低真空度以及常压条件下充型及凝固的规律。结果表明,提高型腔真空度能有效地提高金属液充型能力,避免铸件内气孔的产生,但对缩孔、缩松缺陷的形成没有影响。
|
| 关 键 词： | 真空压铸 真空度 镁合金 充型 气孔 |
Process Simulation of Vacuum Die Casting Magnesium Alloy Steering Gear Process |
| |
| Rao Lei , Zhu Lianbing , Liu Yong , Hu Qiyao. Process Simulation of Vacuum Die Casting Magnesium Alloy Steering Gear Process[J]. Special Casting & Nonferrous Alloys, 2012, 32(7): 637-640 |
| |
| Authors: | Rao Lei Zhu Lianbing Liu Yong Hu Qiyao |
| |
| Affiliation: | 1.School of Mechanical and Electronic Engineering,Hehai University;2.School of Mechanical and Electronic Engineering,Nanchang University) |
| |
| Abstract: | Filling process of vacuum die casting magnesium alloy steering gear was simulated by numerical simulation to understand the filling characteristics of liquid metal under the high vacuum conditions.Based on the simulated results,the filling and solidification of the alloy at high vacuum,low vacuum and conventional die casting were analyzed comparatively.The results show that filling capacity of liquid metal can be improved effectively with increasing in the vacuum degree,eliminating the gas hole defects in the steering gear,however,it is not related to the shrinkage porosity(hole). |
| |
| Keywords: | Vacuum Die Casting Vacuum Degree Magnesium Alloy Filling Pore |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
