| 楔形板带轧制过程跑偏计算模型及其仿真 |
| |
| 引用本文： | 刘义伦,周红平,赵先琼. 楔形板带轧制过程跑偏计算模型及其仿真[J]. 工程设计学报, 2008, 15(6): 444-447. DOI: 10.3785/j.issn.1006-754X.2008.06.012 |
| |
| 作者姓名： | 刘义伦 周红平 赵先琼 |
| |
| 作者单位： | 中南大学,机电工程学院,湖南,长沙,410083 |
| |
| 基金项目： | 教育部科学技术重点资助项目 |
| |
| 摘 要： | 在轧制过程中,由于外扰而引起的板带跑偏现象不能被很好控制,其直接原因在于轧制过程中板带的跑偏量不能精确测量和计算,很难进行精确控制.根据楔形板带轧制过程的物理跑偏模型,建立楔形板带的跑偏计算模型,并利用有限元分析软件,依据现场轧制参数建立有限元轧制模型.仿真结果验证了所建立的计算模型的合理性和精确性.
|
| 关 键 词： | 楔形 跑偏 计算模型 仿真 |
Camber calculating model and simulation of wedge strip in rolling |
| |
| LIU Yi-lun,ZHOU Hong-ping,ZHAO Xian-qiong. Camber calculating model and simulation of wedge strip in rolling[J]. Journal of Engineering Design, 2008, 15(6): 444-447. DOI: 10.3785/j.issn.1006-754X.2008.06.012 |
| |
| Authors: | LIU Yi-lun ZHOU Hong-ping ZHAO Xian-qiong |
| |
| Affiliation: | LIU Yi-lun,ZHOU Hong-ping,ZHAO Xian-qiong(College of Mechanical , Electrical Engineering,Central South University,Changsha 410083,China) |
| |
| Abstract: | In the process of strip rolling, strip deviation caused by outside interference cannot be well controlled. The direct reason of the above problem is that accurate measurement and calculation of camber value are not available, which causes great difficulty of accurate control. This paper establishes camber calculating model based on physical model of wedge strip in rolling. Finite Element Analysis software is utilized to model the strip rolling in light of field data. And simulation of this FEM (finite eleme... |
| |
| Keywords: | wedge camber calculating model simulation |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
| 点击此处可从《工程设计学报》浏览原始摘要信息 |
|
点击此处可从《工程设计学报》下载全文 |
|
