Improvements in Mechanical Properties of 319 Al Alloy Engine Blocks Through Cost-Effective Solution Heat Treatment |
| |
Authors: | A. Lombardi C. Ravindran R. MacKay |
| |
Affiliation: | 1. Centre for Near-net-shape Processing of Materials, Ryerson University, Toronto, ON, Canada 2. Nemak of Canada Corporation, Windsor, ON, Canada
|
| |
Abstract: | The use of Al engine blocks has increased significantly to improve vehicle fuel efficiency. However, the gray cast iron cylinder liners cause the development of large tensile residual stress along the cylinder bores which necessitates the optimization of mechanical properties in this region to prevent premature engine failure. This study compared the microstructure of T4-treated Al billet castings of varying cooling rate to that of the cylinder region of T4-treated (current production schedule) Al engine blocks. The aim of this study was to develop a cost-effective small scale heat treatment optimization method for engine block production. Comparisons in microstructure between the engine block and the billet castings were carried out using optical and scanning electron microscopy. The results suggest that the microstructure and hardness at the top, middle, and bottom of the cylinder were similar to those of each representative billet casting, indicating that heat treatment resulted in successful replication of the engine block locations. In addition, tensile testing revealed that the YS and UTS increased slightly following T4 treatment for all billet castings, which was also observed at the middle of the engine block cylinder bridge. As such, this method can be an effective forerunner for future heat treatment optimization in Al engine block production. |
| |
Keywords: | |
本文献已被 SpringerLink 等数据库收录! |
|