Note: The Use of Triallyl Cyanurate in Bonding PVC Plastisols to Steel

The use of diallyl phthalate as the basis for a non-extractable plasticizer for poly(vinylchloride) (PVC) is well-known. Used in conjunction with a primary plasticizer and a polymerization initiator, a plastisol coating for steel can be formulated which is oil or grease tolerant and can also be used for bonding some structural steel parts if the area is relatively large compared with the load to be applied. Defrayne and Twiss¹ describe the bonding of automobile hood assemblies by vinyl plastisol adhesives and Schneberger² emphasizes their use in the automobile industry though neither article gives the formulations employed. Commercial formulations giving pull-off strengths of the order of 1 to 4 MN. m^-2 always incorporate a proportion of a phenolformaldehyde resin or even an epoxy, but sound-deadening and other coatings of steel do not necessarily need this reinforcement. Phillips and Longworth³ particularly studied the use of diallylphthalate (DAP) as a polymerizable plasticizer and the consequent improvement in adhesion to mild steel. Sherlock⁴ used a simple formulation without additives when investigating the effect of surface cleaning and conversion coatings (oxides and phosphates). It was suggested that, as outlined below, improved adhesion would be expected if a small proportion of triallyl cyanurate (TAC) were added to the polymerizable plasticizer. This paper shows this expectation to be achieved although the proportion of the more expensive TAC needed for substantial increase in bond strength is greater than was hoped.