首页 | 本学科首页   官方微博 | 高级检索  
     

磨削印刷线路板铣刀时的锯齿现象及其消除
引用本文:林高安.磨削印刷线路板铣刀时的锯齿现象及其消除[J].金刚石与磨料磨具工程,2011,31(3):57-60.
作者姓名:林高安
作者单位:厦门金鹭特种合金有限公司,厦门,361006
基金项目:国家科技支撑计划(2007BAE05B03)
摘    要:本文针对金刚石砂轮磨削印刷线路板(PCB)铣刀过程中铣刀切削刃产生的锯齿现象进行了分析,研究了砂轮粒度、砂轮转速以及切沟速度对铣刀切削刃锯齿的影响.研究结果表明,随着砂轮粒度的减小,切削刃质量得到提高,砂轮转速和切沟速度对切削刃质量都有影响,其中砂轮粒度对切削刃质量的影响最为重要.

关 键 词:金刚石砂轮  PCB用铣刀  刀刃锯齿现象

The aliasing phenomenon and its elimination during the grinding of PCB milling cutters
Lin Gao'an.The aliasing phenomenon and its elimination during the grinding of PCB milling cutters[J].Diamond & Abrasives Engineering,2011,31(3):57-60.
Authors:Lin Gao'an
Affiliation:Lin Gao′an(Xiamen Golden Egret Special Alloy Co.Ltd.,Xiamen 361006,China)
Abstract:The edge aliasing phenomenon on the cutter used for printed circuit board(PCB) milling often occur during the grinding with diamond wheel.In this paper,the effects of wheel diamond grit size,wheel speed and feed rate on the edge aliasing were studied.The results showed that the quality of cutting edge of milling cutter was improved with the decrease of wheel diamond grit size.The wheel speed and feed rate also had influence on the quality of the cutting edge.The wheel diamond grit size was the most importan...
Keywords:diamond wheel  cutters for PCB milling  aliasing edge  
本文献已被 CNKI 维普 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号