| 焊后热处理对ASTM 4130钢焊接接头组织与性能的影响 |
| |
| 引用本文： | 薄国公,王勇,韩涛,李立英.焊后热处理对ASTM 4130钢焊接接头组织与性能的影响[J].压力容器,2011,28(7):11-16. |
| |
| 作者姓名： | 薄国公 王勇 韩涛 李立英 |
| |
| 作者单位： | 中国石油大学机电工程学院,山东东营,257061 |
| |
| 基金项目： | 国家“863”高技术研究发展计划资助项目 |
| |
| 摘 要： | 通过金相观察、硬度和冲击试验,研究了不同保温时间的焊后热处理（PWHT）对ASTM 4130钢焊接接头显微组织、硬度、低温韧性的影响。结果表明,PWHT后,焊缝组织为铁素体、少量珠光体和碳化物,HAZ组织主要为回火索氏体、铁素体和贝氏体;造成熔合线附近硬度较高、韧性较低的原因是组织的粗化和上贝氏体的形成;随PWHT保温时间的延长,接头硬度降低,韧性改善。这主要是由于保温时间延长,使碳化物逐渐析出,其弥散强化效应和回火索氏体中合金元素固溶强化效应降低,同时,碳化物弥散度的降低也使得接头应力集中程度降低。
|
| 关 键 词： | ASTM 4130钢 焊后热处理 焊接接头 微观组织 力学性能 |
Effect of Post -weld Heat Treatment on Microstructure and Mechanical Properties of Welded Joints of ASTM 4130 Steel |
| |
| BO Guo-gong,WANG Yong,HAN Tao,LI Li-ying.Effect of Post -weld Heat Treatment on Microstructure and Mechanical Properties of Welded Joints of ASTM 4130 Steel[J].Pressure Vessel Technology,2011,28(7):11-16. |
| |
| Authors: | BO Guo-gong WANG Yong HAN Tao LI Li-ying |
| |
| Affiliation: | BO Guo-gong,WANG Yong,HAN Tao,LI Li-ying (College of Mechanical and Electronic Engineering in China University of Petroleum,Dongying 257061,China) |
| |
| Abstract: | The effect of post-weld heat treatment(PWHT) on microstructure,hardness,low temperature impact toughness and fracture morphology of welded joints of ASTM 4130 steel was systematically investigated by using optical microscopy,hardness and impact tests.The results show that the microstructures of weld metal are ferrite,a small mount of pearlite and carbide,and typical heat-affected zone(HAZ) microstructures are comprised of tempered martensite,ferrite and bainite after PWHT.Higher hardness and lower impact to... |
| |
| Keywords: | ASTM 4130 steel post-weld heat treatment welded joints microstructure mechanical properties |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
