| 熔模铸造发泡涂料和多孔性型壳的研究 |
| |
| 引用本文： | 张启富,佟天夫.熔模铸造发泡涂料和多孔性型壳的研究[J].特种铸造及有色合金,1994(5):6-8,23. |
| |
| 作者姓名： | 张启富 佟天夫 |
| |
| 作者单位： | 内蒙古工学院 |
| |
| 摘 要： | 往精铸加固层涂料中国发泡剂和稳泡剂以制成发泡涂料并用之制成多孔性型壳，在保证型壳显态强度和高温强度的基础上，降低其残留强度，改善溃散性。文中讨论了发泡涂料中气泡分布状态，密度，粘度，屈服值和涂片重等。还讨论了多孔性型壳的湿态，高温和残留强度以及溃散率等。。
|
| 关 键 词： | 熔模铸造 发泡涂料 多孔性型壳 铸型 |
Investigation on Foaming Slurry and Porous Ceramic Shell Mould in investment Casting |
| |
| Zhang Qifu.Investigation on Foaming Slurry and Porous Ceramic Shell Mould in investment Casting[J].Special Casting & Nonferrous Alloys,1994(5):6-8,23. |
| |
| Authors: | Zhang Qifu |
| |
| Affiliation: | Zhang Qifu(Huazhong University of Science and Technology)Tong Tianfu(Inner Mongol institute of Technology) |
| |
| Abstract: | The porous ceramic shell mould was made of foaming slurry by adding foaming agents and foam stabilizer. It can be reduce remaind strength and improve collapsibility but withsufficient green and high temperature strength and casting surface quality.The distuibution of airbubble, density, viscosity,yield value,desposite weight of slurry and green strength, high temperature strength,remaind strength and rate of collabsibility of porous ceramic shell mould were alsodiscussed in this paper. |
| |
| Keywords: | Investment casting Foaming slurry Porous ceramic shell |
| 本文献已被 CNKI 维普 等数据库收录！ |
