| 黄麻毡/PP膜复合汽车内饰材料的制备及工艺优化 |
| |
| 引用本文： | 陈超,于永玲,吕丽华,刘润华.黄麻毡/PP膜复合汽车内饰材料的制备及工艺优化[J].大连工业大学学报,2011,30(4):303-305. |
| |
| 作者姓名： | 陈超 于永玲 吕丽华 刘润华 |
| |
| 作者单位： | 大连工业大学绿色纤维应用技术研究所,辽宁大连,116034 |
| |
| 基金项目： | 辽宁省教育厅科学研究计划项目 |
| |
| 摘 要： | 黄麻毡/PP膜制备的复合材料用于汽车内饰,具有质轻、强力高及绿色环保等优点.探讨了黄麻毡/PP膜通过层压法制备汽车内饰材料的工艺方法.采用正交和单因素分析法优选了黄麻毡与PP膜复合制备的工艺参数.结果表明,当PP膜与黄麻毡质量比为40:60时,所制备复合材料的拉伸强度和弯曲强度在工艺条件为热压温度180℃、热压压力10...
|
| 关 键 词： | 黄麻毡 PP膜 汽车内饰材料 拉伸强度 弯曲强度 |
Process optimization of jute felt/PP film composites for automobile components |
| |
| CHEN Chao,YU Yong-ling,LV Li-hua,LIU Run-hua.Process optimization of jute felt/PP film composites for automobile components[J].Journal of Dalian Dalian Polytechnic University,2011,30(4):303-305. |
| |
| Authors: | CHEN Chao YU Yong-ling LV Li-hua LIU Run-hua |
| |
| Affiliation: | Green Fiber Application Technology Research Institute,Dalian Polytechnic University,Dalian 116034,China |
| |
| Abstract: | The processes of jute felt/PP film composites made by hot pressing were discussed and the optimal process was given by orthogonal test and single factor analysis.The results showed that jute felt/PP film composites with ideal tensile strength and flexural strength could be obtained when the mass ratio of jute multi-layer and PP film was 40:60,in the condition of hot-pressing temperature 180 ℃,hot-pressing pressure 10 MPa and hot-pressing time 9 min. |
| |
| Keywords: | jute felt PP film automobile components tensile strength flexural strength |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
