首页 | 本学科首页   官方微博 | 高级检索  
     

TZP陶瓷的高温润滑研究
引用本文:刘惠文,薛群基.TZP陶瓷的高温润滑研究[J].无机材料学报,1997,12(5):681-686.
作者姓名:刘惠文  薛群基
作者单位:中国科学院兰州化学物理研究所固体润滑开放研究实验室; 兰州730000
基金项目:国家自然科学基金!59332060,甘肃省自然科学基金ZR-95-074赞助
摘    要:研究了TZP陶瓷在固体润滑下,室温(25℃)至600℃制备范围内的摩擦学特性.结果表明,使用石墨和MoS2润滑剂,可在室温至600℃范围内降低TZP/Si3N4摩擦副的摩擦系数和磨损率,但当环境温度过高时,摩擦系数和磨损量有所增加;使用CeO2和Cu对TZP/Si3N4摩擦副的摩擦系数影响不大,但可以降低TZP陶瓷的磨损量;CeF3在高温时,由于结晶化趋势完善及沿(002)面的滑移取向,故可对TZP陶瓷起到良好的润滑作用.

关 键 词:四方氧化锆陶瓷  摩擦  磨损  润滑  
收稿时间:1996-10-14
修稿时间:1996-11-1

High Temperature Lubrication of TZP Ceramics
LIU Huiwen,XUE Qunji.High Temperature Lubrication of TZP Ceramics[J].Journal of Inorganic Materials,1997,12(5):681-686.
Authors:LIU Huiwen  XUE Qunji
Affiliation:Laboratory of Solid Lubrication; Lanzhou Institute of Chemical Physics; Chinese Academy of Sciences Lanzhou 730000 China
Abstract:The tribological properties of TZP ceramics under solid lubrication up to 600℃ were investigated. Using either graphite or MoS2 can reduce the friction coefficient and wear rate of TZP/Si3N4 sliding couple from 25 to 600℃, however, their lubricating characteristics can be deteriorated due to the oxidation of these lubricants over excessive high temperature. Using CeO2 and Cu can reduce the wear rate of TZP ceramics, but they don’t have apparently influence on the friction coeffcient. CeF3 has good lubricating properties at high temperature, which is due to its completed crystallization and orientation alone (002) plane.
Keywords:TZP ceramics  friction  wear  lubrication
本文献已被 CNKI 维普 等数据库收录!
点击此处可从《无机材料学报》浏览原始摘要信息
点击此处可从《无机材料学报》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号