| MC尼龙/纳米Al2O3复合材料力学性能的研究 |
| |
| 引用本文： | 郑立允,赵立新,牛兰芹. MC尼龙/纳米Al2O3复合材料力学性能的研究[J]. 工程塑料应用, 2004, 32(8): 12-14 |
| |
| 作者姓名： | 郑立允 赵立新 牛兰芹 |
| |
| 作者单位： | 1. 河北工程学院机械系,邯郸,056038;华中科技大学模具技术国家重点实验室,武汉,430074
2. 河北工程学院机械系,邯郸,056038 |
| |
| 基金项目： | 河北省教育厅自然科学研究项目(Z2003103) |
| |
| 摘 要： | 采用原位聚合技术制备了纳米Al2O3增强单体浇铸(MC)尼龙复合材料,用扫描电子显微镜观察其断口形貌纳米粒子分布状况,并测试、分析了纳米Al2O3含量对对材料力学性能的影响。结果表明，采用原位聚合技术可获得的纳米粒子分布均匀、综合性能优良的纳米复合材料，当纳米Al2O3质量分数的4%时，MC尼龙/纳米Al2O3复合材料的拉伸强度、冲击强度和弯曲强度均达到最大值，分别比纯MC尼龙提高了19%、33%和11%。
|
| 关 键 词： | 原位聚合 纳米复合材料 浇铸尼龙 复合材料 力学性能 |
| 修稿时间： | 2004-05-11 |
STUDY ON MECHANICAL PROPERTY OF MC NYLON/NANO-Al2O3 COMPOSITE |
| |
| Zheng Liyun ,,Zhao Lixin ,Niu Lanqin. STUDY ON MECHANICAL PROPERTY OF MC NYLON/NANO-Al2O3 COMPOSITE[J]. Engineering Plastics Application, 2004, 32(8): 12-14 |
| |
| Authors: | Zheng Liyun Zhao Lixin Niu Lanqin |
| |
| Affiliation: | Zheng Liyun 1,2,Zhao Lixin 1,Niu Lanqin 1 |
| |
| Abstract: | MC nylon/nano-Al 2O 3 composites were prepared by in situ polymerization. Through scanning electron microscope, the nano-composites fructure morphology and nano-particle distribution were observed. The effects of nano-Al 2O 3 content on the mechanical properties of composites were analyzed. The results showed that the nano-composites of well dispersed particles and good integrative properties were obtained by in situ polymerization. And the tensile strength, impact strength, and flexural strength of MC nylon/nano-Al 2O 3 composites reached the maximum which were 119%, 133%, and 111% higher respectively than those of pure MC nylon, in the case of 4% nano-Al 2O 3 particles. |
| |
| Keywords: | nano-composite MC nylon in situ polymerization mechanical property |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
