| 有限元法计算铝带轧机的辊系变形 |
| |
| 引用本文： | 刘华,杨荃,何安瑞. 有限元法计算铝带轧机的辊系变形[J]. 轻金属, 2005, 0(11): 60-63 |
| |
| 作者姓名： | 刘华 杨荃 何安瑞 |
| |
| 作者单位： | 北京科技大学高效轧制国家工程研究中心,北京,100083 |
| |
| 摘 要： | 用ANSYS有限元方法建立了铝带轧机辊系变形数学模型。分别计算了不同轧件宽度时各轧制道次辊缝处轧辊的变形，以及工作辊与支持辊间的压扁和压力的轴向分布。分析了不同轧件宽度时各道次铝带的比例凸度及对板形的影响，与现场板形目测情况吻合。该计算方法可用做厚度大于0.1mm的铝带轧机辊系变形数学模型。
|
| 关 键 词： | 铝带轧机 板形 轧制道次 有限元法 |
| 文章编号： | 1002-1752(2005)11-0060-04 |
| 收稿时间： | 2004-08-06 |
| 修稿时间： | 2004-08-06 |
Finite element analysis of rolls deformation on aluminum strip mill |
| |
| LIU Hua,YANG Quan,HE An-rui. Finite element analysis of rolls deformation on aluminum strip mill[J]. Light Metals, 2005, 0(11): 60-63 |
| |
| Authors: | LIU Hua YANG Quan HE An-rui |
| |
| Abstract: | The rolls deformation maths model of the aluminum foil mill is established by a finite element measure.The work roll deformation in the roll gap and the deformation & perssure between the work roll and back-up roll of every pass under different width of aluminum foil are calculated,the influence on the profile of different width aluminum foil proportion crown of every pass is explained.It is coincident to the locale profile by eyes.This method can be used as the maths model of the aluminum foil mill rolls deformation when the thichness of the aluminum foil is bigger than 0.1mm. |
| |
| Keywords: | |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
