Effect of Surface Energetics of Substrates on Adhesion Characteristics of Poly (p-xylylenes) |
| |
Authors: | Ashok K Sharma H Yasuda |
| |
Affiliation: | Department of Chemical Engineering and Graduate Center for Materials Research , University of Missouri-Rolla , Rolla , Missouri , 65401 , U.S.A. |
| |
Abstract: | In investigating the effect of the surface energetics of substrate materials on the adhesion characteristics of poly(p-xylylene) and poly(chloro-p-xylylene) by the “Scotch Tape” method, it was found that if the substrates had not been preconditioned (treated with argon or a methane plasma), the adhesion was poor. The characteristics of water resistant adhesion that were observed when coated substrates were boiled in 0.9% sodium chloride solution were found to vary from excellent (when the polymer did not peel from the substrate after three cycles of 8 hours of boiling and 16 hours at room temperature) to poor (when the polymer peeled off almost immediately). It was noticed that water resistant adhesion depends on the hydrophobicity of the substrate material (the greater the hydrophobicity, the greater the adhesion) and is not related to the dry adhesive strength of poly(p-xylylene). The oxygen glow discharge treatment of the substrates decreased both the dry and wet adhesive strength of the polymer. The effect of the argon glow discharge treatment depended on the surface energetics of the substrate, and the methane glow discharge treatment increased both the dry and wet adhesive strength of the polymer. These preconditioning processes are discussed in terms of the sputtering of the material from the wall of the reactor in contact with the plasma and the deposition of the plasma polymer of the sputtered material on the substrate surface. |
| |
Keywords: | polymers plasma treatment effect of air exposure adhesion ageing XPS contact angle measurements |
|
|