| 扫描速度对激光熔覆Ni基涂层组织性能的影响 |
| |
| 引用本文： | 邱星武,李刚,任鑫,邱玲. 扫描速度对激光熔覆Ni基涂层组织性能的影响[J]. 稀有金属材料与工程, 2009, 38(Z1) |
| |
| 作者姓名： | 邱星武 李刚 任鑫 邱玲 |
| |
| 作者单位： | 辽宁工程技术大学,辽宁,阜新,123000 |
| |
| 摘 要： | 采用CO2激光器及LASERCELL-1005六轴六联动三维激光加工机床对40Cr钢进行熔覆处理,采用微观分析及力学性能测试手段对熔覆层组织及性能进行研究.结果表明:熔覆层由熔覆区(CZ)、结合区(BZ)和基底热影响区(HAZ)三部分组成.对应的组织分别为:细小的树枝晶与等轴晶、平面晶与树枝晶、针状马氏体;随扫描速度增加,熔覆层组织变得细小均匀,硬化层深加深,显微硬度、耐磨性、耐蚀性增加;激光熔覆后的硬度、耐磨性、耐蚀性都有很大提高,其最大值分别约为基体的4、4.3、30倍.
|
| 关 键 词： | 激光熔覆 扫描速度 Nj基涂层 组织 性能 |
Influence of Scanning Speed on Microstructure and Properties of Ni Based Laser Cladding Coating |
| |
| Qiu Xingwu,Li Gang,Ren Xin,Qiu Ling. Influence of Scanning Speed on Microstructure and Properties of Ni Based Laser Cladding Coating[J]. Rare Metal Materials and Engineering, 2009, 38(Z1) |
| |
| Authors: | Qiu Xingwu Li Gang Ren Xin Qiu Ling |
| |
| Affiliation: | Qiu Xingwu,Li Gang,Ren Xin,Qiu Ling (Liaoning Technical University,Fuxin 123000,China) |
| |
| Abstract: | CO2 laser and the LASERCELL-1005 six axes sixlinkages three dimensional laser processing machine tools were used for laser cladding process on 40Cr with Ni60B alloy powder. The microstructure and properties of cladding coating were researched by means of micro-analysis and mechanical property testing. The result indicated that,the coatings of laser cladding were constituted of cladding zone (CZ),bonding zone (BZ) and heat affected zone (HAZ). The corresponding microstructures were fine dendrites and equiaxi... |
| |
| Keywords: | laser cladding scanning speed Ni-based coatings microstructure properties |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
