Effect of longwall-induced subsurface deformations on shale gas well casing stability under deep covers

This paper presents the results of a 2017 study conducted by the National Institute for Occupational Safety and Health(NIOSH), Pittsburgh Mining Research Division(PMRD), to evaluate the effects of longwall-induced subsurface deformations within a longwall abutment pillar under deep cover. The 2017 study was conducted in a southwestern Pennsylvania coal mine, which extracts 457 m-wide longwall panels under 361 m of cover. One 198 m-deep, in-place inclinometer monitoring well was drilled and installed over a 45 m by 84 m center abutment pillar. In addition to the monitoring well, surface subsidence measurements and underground coal pillar pressure measurements were conducted as the 457 m-wide longwall panel on the south side of the abutment pillar was being mined. Prior to the first longwall excavation, a number of simulations using FLAC3D~(TM) were conducted to estimate surface subsidence, increases in underground coal pillar pressure, and subsurface horizontal displacements in the monitoring well. Comparisons of the pre-mining FLAC3D simulation results and the surface, subsurface,and underground instrumentation results show that the measured in-place inclinometer casing deformations are in reasonable agreement with those predicted by the 3D finite difference models. The measured surface subsidence and pillar pressure are in excellent agreement with those predicted by the 3D models.Results from this 2017 research clearly indicate that, under deep cover, the measured horizontal displacements within the abutment pillar are approximately one order of magnitude smaller than those measured in a 2014 study under medium cover.