首页 | 本学科首页   官方微博 | 高级检索  
     

基于单火线的LED照明灯调光方法
引用本文:罗树英,凌 云,李 勇,李 飞.基于单火线的LED照明灯调光方法[J].湖南工业大学学报,2015,29(3):63-66.
作者姓名:罗树英  凌 云  李 勇  李 飞
作者单位:湖南工业大学 电气与信息工程学院,湖南工业大学 电气与信息工程学院,湖南工业大学 电气与信息工程学院,湖南工业大学 电气与信息工程学院
基金项目:湖南省自然科学基金资助项目(13JJ9016)
摘    要:针对开关通断控制技术的单火线调光方法,只能提供4档LED照明灯的调节亮度,且对开关动作有时间要求的弊端,提出一种用单火线亮度控制电路、亮度信号接收电路和亮度控制驱动电路来实现的LED照明灯调光方法。该方法采用控制双向晶闸管正负半波是否移相触发,以单火线方式给出LED照明灯亮度增加控制信号或者亮度减小控制信号,由MCU对亮度控制信号进行识别,微控制器输出占空比可调节PWM信号来控制LED照明灯亮度在0~100%之间以1%的步进值改变。

关 键 词:LED照明灯  单火线  调光  亮度控制信号
收稿时间:4/3/2015 12:00:00 AM

LED Lamp Dimming Method Based on Single Power Line
Luo Shuying,Ling Yun,Li Yong and Li Fei.LED Lamp Dimming Method Based on Single Power Line[J].Journal of Hnnnan University of Technology,2015,29(3):63-66.
Authors:Luo Shuying  Ling Yun  Li Yong and Li Fei
Abstract:As the dimming method of single power line based on the switch on-off control technology only provides 4-grade brightness adjusting for LED lights and has requirement for the switching operation time, proposes a method of the single power line brightness control circuit, the luminance signal receiving circuit and the brightness control drive circuit to achieve LED dimming. The method adopts the bidirectional thyristor positive and negative half wave to control phase-shift trigger, gives the LED lamp control signals of increasing or decreasing brightness by single power line and identifies the brightness control signals by MCU. The micro controller output duty ratio can adjust the PWM signals to control LED lamp brightness changing between 0 and 100% with 1% step value.
Keywords:
本文献已被 CNKI 等数据库收录!
点击此处可从《湖南工业大学学报》浏览原始摘要信息
点击此处可从《湖南工业大学学报》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号