Recycling of aluminum dross and silica fume wastes for production of mullite-containing ceramics: Powder preparation,sinterability and properties

The improper disposal of industrial wastes causes environmental pollution so their recycling for fabrication of new products became an interesting research issue. In this work, sintered mullite-containing ceramics were prepared from aluminum dross and silica fume (up to 40 wt%) waste materials after sintering up to 1500 °C. Before sintering, the starting waste materials were converted into nano powders by mechanical milling alloying method up to 15 h. The obtained waste nano powders were investigated using different techniques as X-ray diffraction (XRD), transmission electron microscope (TEM) and scanning electron microscope (SEM). On the other hand, phase identification by XRD, physical properties determination (bulk density and apparent porosity), microstructure by SEM, mechanical and electrical properties of sintered bodies were investigated. The results revealed that mullite phase was formed in higher amounts with increasing both sintering temperature (1500 °C) and silica fume content. At 1300 °C, amorphous mullite was formed in addition to the alumina phase. It is also noted that the apparent porosity and bulk density were reduced with increasing silica content. However, they exhibited opposite trend when the temperature increased from 1300 into 1500 °C. Moreover, with increasing the mullite content, the microhardness, compressive strength, Younges modulus and electrical conductivity were decreased and reached 10.2 GPa, 216.9 MPa, 119.7 GPa and 4.9 × 10 ^?12 S/m, respectively, for the sample that contained higher amount of mullite, while the fracture toughness was improved and reached to 3.44 MPa m^0.5.