Fabricating nanostructures through a combination of nano-oxidation and wet etching on silicon wafers with different surface conditions

This study investigates the surface conditions of silicon wafers with native oxide layers (NOL) or hydrogen passivated layers (HPL) and how they influence the processes of nano-oxidation and wet etching. We also explore the combination of nano-oxidation and wet etching processes to produce nanostructures. Experimental results reveal that the surface conditions of silicon wafers have a considerable impact on the results of nano-oxidation when combined with wet etching. The height and width of oxides on NOL samples exceeded the dimensions of oxides on HPL samples, and this difference became increasingly evident with an increase in applied bias voltage. The height of oxidized nanolines on the HPL sample increased after wet etching; however, the width of the lines increased only marginally. After wet etching, the height and width of oxides on the NOL were more than two times greater than those on the HPL. Increasing the applied bias voltage during nano-oxidation on NOL samples increased both the height and width of the oxides. After wet etching however, the increase in bias voltage appeared to have little effect on the height of oxidized nanolines, but the width of oxidized lines increased. This study also discovered that the use of higher applied bias voltages on NOL samples followed by wet etching results in nanostructures with a section profile closely resembling a curved surface. The use of this technique enabled researchers to create molds in the shape of a silicon nanolens array and an elegantly shaped nanoscale complex structures mold.