| 永磁同步电动机矢量控制的研究与分析 |
| |
| 引用本文： | 陈钱春,阮毅,王仁峰.永磁同步电动机矢量控制的研究与分析[J].电机与控制应用,2007,34(2):25-28. |
| |
| 作者姓名： | 陈钱春 阮毅 王仁峰 |
| |
| 作者单位： | 上海大学机电工程与自动化学院 上海200072 |
| |
| 摘 要： | 利用MATLAB仿真软件建立了两种常用的永磁同步电动机矢量控制方案的仿真模型,即id=0控制和最大转矩/电流控制。从控制算法、功率因数、对参数的鲁棒性等方面比较了两种控制方案各自的优缺点。研究表明,最大转矩/电流控制算法复杂,对参数的鲁棒性不高,但在功率因数方面要高于id=0控制。给出了两种控制方案的仿真结果。
|
| 关 键 词： | 永磁同步电动机 矢量控制 最大转矩/电流控制 |
| 文章编号： | 1673-6540(2007)02-0025-04 |
| 修稿时间： | 2004年3月17日 |
Research and Analysis of Vector Control for Permanent Magnet Synchronous Motor |
| |
| CHEN Qian-chun,RUAN Yi,WANG Ren-feng.Research and Analysis of Vector Control for Permanent Magnet Synchronous Motor[J].Electric Machines & Control Application,2007,34(2):25-28. |
| |
| Authors: | CHEN Qian-chun RUAN Yi WANG Ren-feng |
| |
| Abstract: | In this paper, two vector control models for permanent magnet synchronous motor (PMSM) are established with MATLAB, which are i_d=0 control scheme and the maximum torque per armature current control scheme. By analyzing the two control schemes theoretically, the arithmetic, power factor and the robustness for the parameters of the motor are compared between two control schemes. Research shows that the power factor with maximum torque per armature current control scheme is better, but the arithmetic is more complicated, and the robustness is worse. The experiments results are also discussed. |
| |
| Keywords: | permanent magnet synchronous motor vector control maximum torque per armature current control |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
