| 半固态Al—4Cu—Mg合金加工图研究 |
| |
| 引用本文： | 余小鲁,李付国.半固态Al—4Cu—Mg合金加工图研究[J].安徽机电学院学报,2009(4):46-48. |
| |
| 作者姓名： | 余小鲁 李付国 |
| |
| 作者单位： | [1]安徽工程科技学院机械工程系,安徽芜湖241000 [2]西北工业大学材料学院,陕西西安710072 |
| |
| 基金项目： | 基金项目：安徽工程科技学院青年科研基金资助项目（2007yq008zd）;安徽省高校自然科学基金资助项目（kj2009b134） |
| |
| 摘 要： | 根据动态材料模型。建立了半固态Al-4Cu—Mg合金加工图．利用加工图确定了试验材料热变形的流变失稳区，结果表明半固态成形时的流变失稳区范围与应变速率有关．此外，获得了等温压缩试验参数范围内的热变形最佳工艺参数，半固态加工最佳工艺参数为加热温度560℃，应变速率0．001s^-1。
|
| 关 键 词： | Al-4Cu—Mg合金 半固态 加工图 工艺参数 |
On processing maps of semi-solid Al-4Cu-Mg Alloy |
| |
| YU Xiao-lu,LI Fu-guo.On processing maps of semi-solid Al-4Cu-Mg Alloy[J].Journal of Anhui Institute of Mechanical and Electrical Engineering,2009(4):46-48. |
| |
| Authors: | YU Xiao-lu LI Fu-guo |
| |
| Affiliation: | 1. Dept. of Mech. Engru , Anhui University of Technology and Science, Wuhu 241000, China 2. Sch. of Mate. Sei. , North-western Polytechnical University, Xi＇an 710072, China) |
| |
| Abstract: | Based on the dynamic materials model, the processing maps of Al-4Cu-Mg alloy in the states of semi-solid and solid were established. The instability zones of flow behavior can be recognized by maps, which show that semi-solid forming is more sensitive to strain rate than solid forming. The optimal process parameters in the temperature range and different strain rate can also be obtained by the maps. The semi-solid forming temp＇erature is approximately 560 ℃ and strain rate is about 0.001 s^-1. The solid forming temperature is approximately 400 ℃ and strain rate is also about 0.001 s^-1. |
| |
| Keywords: | Al-4Cu-Mg alloy semi-solid processing map process parameter |
| 本文献已被 维普 等数据库收录！ |
